✨ Sabine Wren Lightsaber – Designed to Match Core・ STL File for 3D printing・Cults

Thanks a lot for taking the time to view my itemizing!

3D mannequin of Sabine Wrens Lightsaber from Ahsoka

The Mannequin is designed to suit a normal Lightsaber 1″ Core from most Saber Producers (NOT INCLUDED) and 1″ Blade.

To be used in Cosplay Solely not for Dueling.

The design was modeled on my own in TinkerCAD and used for my very own Cosplay.
-These are Print Recordsdata ONLY not completed merchandise.
-Meeting is simple, components that require multiples are marked in brackets on Filename.
-Suggest utilizing 15-minute epoxy for meeting.

With this file, you’ll be able to:
– Print and use the 3D prints of the 3D mannequin for personal use, in limitless amount
– Share the pictures of your 3D prints of the 3D mannequin on communication media corresponding to social networks or web sites.

You cannot (with out direct permission):
– Commercially use or publicly share the 3D mannequin or 3D prints produced utilizing the mannequin (or its derivatives)
– Modify or adapt the 3D mannequin for public sharing or sale
– Distribute, promote, donate or change the digital recordsdata of the 3D mannequin.

By buying and downloading this file you agree to those phrases and circumstances.

The physique is greatest printed at a slight angle to each permit it to suit on smaller printers and to ensure the layer traces don’t run 90 levels to the core. Suggest utilizing at the least 4 wall thickness for power. We print ours in ABS because it’s barely simpler to sand for a end.

The primary physique could require some sanding, relying in your print high quality, the higher emitter is modeled with a clearance as this half wants to slip over components that require portray.
All the time make sure you dry match the components previous to portray and glueing. For glue we use 10 min epoxy with some tremendous glue spots to assist repair in place whereas it units.

Make sure you faucet the threads into the Core tube for the Core energy change and blade set screws previous to meeting as this may be tough as soon as assembled. We discovered that these have been screwed in with out the necessity to warmth the screws, however some have used a soldering iron to heat them earlier than screwing them in to assist the threads kind.

.

The pommel will be glued into place on the backside. It is designed to be a decent friction match in case you don’t wish to glue it to permit entry to the underside within the occasion that the core will get caught.

We’ve discovered that the Core set screw that pushes out the ability backside is normally sufficient to carry the core in place. Guarantee you’ve the change the right method round(gap Nearer to the highest of the saber). The small change glues straight concerning the giant change within the recessed gap.

Lastly the Emitter high will be glued on, its been modeled barely bigger so it mustn’t scratch the paint on the high of the Core tube whenever you slide it over.